Save on chemical products consumption when your sludge concentration is not constant

Auxiliary

CMC – Microwave Total Solids Meter
Cerlic

The CMC Total Solids Meter is an excellent tool for continuous Total Solids measurement in WWTP applications. With this measurement, the VOLUTE™ Control Panel can instruct either the feed pump to adjust the inlet flow or the polymer station to adapt the polymer dosing when sludge concentrations vary.

Consultation & Quotation Brochure Download

ADVANTAGES

The Microwave TS Meter enables savings on polymer dosing and enhances process control

The sensor uses the reliable and well-tested measuring principle of microwave true-phase technology, utilizing 5 frequencies to achieve higher accuracy and automatic recovery after an empty pipe situation. The true-phase technology has a wide measurement range of TS concentrations. The rugged design without moving parts ensures high reliability and minimum maintenance. The microwave sensor is available in size DN50 to DN300 (3” to 2”).

Key Benefits

  • Maintenance free tool
  • Single point calibration for all concentrations
  • Low installation and lifetime costs
  • Reliable & accurate
  • Not affected by process or media changes
  • Easy-to-use display
  • Wide TS measurement range

No TS/TSS meter

With varying concentrations of solids and a fixed polymer dosage set point, both overdosing and underdosing will occur, leading to increased costs.

With TS/TSS meter

By using a TS/TSS meter to monitor the variation of the concentration of solids, a predefined dose of polymer is always applied according to the measured amount of solids in the sludge. This prevents over- or under-dosing, resulting in cost savings.
List of Case Studies

Flow for Product Installation

流れ
Feel free to contact us. After collecting information about your treatment process and needs, we will recommend the most suitable model for your situation. You can use our free sample analysis service if you are unsure about dosage rates and polymer type; we will send you a report stating the expected amount and type of polymer to be dosed, dry solids content of the dewatered cake, recommended technology, etc. Based on your requests we will then prepare a tailored solution proposal. Before handover of the equipment, our service engineer will commission the unit on site and train the local operators to ensure the optimal result for you.
バナー
バナー